E30 Rear Subframe Camber or Toe Correction Kits (e30, e28, e34, z3)

E30 Rear Subframe Camber or Toe Correction brackets

The stock e30, e28, e32 and e34 rear subframes does not allow you to align the rear wheels. Alignment is a critical point in spec e30 as well as general tracking/autocrossing. A must when lowering your car. Its night and day diffrence. When an e30 is lowered, the car has alot of negative camber. Although this is wanted by some, it can be excessive. These brackets get welded to the rear subframe on the rear control arm mounting points. You slot the orginal hole and have these professionally welded in place. Then using OEM essentric BMW hardware the rear of your e30 can be aligned! We offer the welding service in our huntington beach location. So drop it off of ship it to us!

Can be used for BMW e28, e30, e32, e34, e36 318ti, and Z3. These are spec e30 legal! Professional installation recommended. WELDING REQUIRED!

Whats included and which kit do I need? camber or toe? Both?

Each "kit" includes 4 brackets. This is enough to do either camber or toe on your e30. You need to order 2 kits to make the rear subframe fully adjustable for both camber AND toe. The subframe has 8 mounts (2 mounts on outside and 2 mounts on each wheel) . So to correct camber the brackets go on the inner mounts (closest to diff), and toe would go to the outer mounts (closest to the wheels). The camber brackets (inner tabs) should be welded with the slots going up and down. The toe bracket (outer tabs) slots should be horizontal.

To make sure you get the right order:

One kit will do either toe OR camber.

Two kits will do both toe AND camber.

HARDWARE INFO: Please be sure to check if you want the genuine BMW OEM Hardware( Inlcudes Eccentric Bolts, Eccentric Washers and Bolts)

 

Click here to purchase kit!

 

E30-Rear-Subframe-Camber-and-Toe-Correction-Kits

 

 

Click here to purchase